Aim Motorsport Brake Pressure Dash 3 0-100 bar 0-160 bar

  • £180.00
    Unit price per 
Tax included.


The Aim Brake Pressure Sensor Dash 3 is fitted with a 719 plastic binder connector to fit on to Aim systems or extension leads. This is classed as an analog sensor, so will use one analog input on the logger or display.

    This can be used not only to see brake pressure, but allows you to see braking points both start and end also if the driver is getting tired when braking or the brake system is becoming in-effective,

    Running this in conjunction with a throttle sensor, also allows you to see coasting time which is the most important thing to reduce, to gain more lap time.
    How to set up on a Pressure sensor on a AIM Data logger System using Race Studio 2.
    Go to the Race Studio 2 software and open the programme, on the top bar double click customise sensor, when the box opens, in type of measure select pressure.
    Next,
    On line 1, in the X column type 500, and in the Y column type 0
    Then
    10 Bar - On line 2 in the X column type 4500 and in the Y column type 10
    100 Bar - On line 2 in the X column type 4500 and in the Y column type 100
    Then press the compute Curve button, this should create the liner graph for you.
    Lastly Rename your sensor as you wish, so you recognise it, then press the save button.
    Now exit, to locate the sensor and assign it to your logger, go to Device Configuration, and the sensor will be in the drop down selection of sensors on the Sensor type under the channels tab.
    How to set up on a Pressure sensor on a AIM Data logger System using Race Studio 3.
    Open Race Studio 3 software, in the top left, on the configuration buttons, click custom sensor, when the box opens, then click on the New button in the top middle of the screen,
    This brings up a custom sensor configuration screen.
    in type of measure type box select Pressure
    in calibrate type leave as none.
    Input type is mV.
    Next,
    On line 1, in the X column type 500, and in the Y column type 0
    Then
    10 Bar - On line 2 in the X column type 4500 and in the BAR column type 10
    100 Bar - On line 2 in the X column type 4500 and in the BAR column type 100
    Press enter.
    This should create the liner graph for you.
    Lastly Rename your sensor as you wish, in the top box, in Sensor Name, so you recognise it, then press the save button, and the close button.
    Now go back to the dash configuration, choose your dash setup from the Devise Configuration, click on the channel you have input the sensor too, select function as pressure, and oil Pressure, this then should bring your custom sensor up in the sensor list, then check all is setup right and press save.
    Extra Information.
    Electrical Connections :
    Red: +VB Supply
    Blue : 0v Common
    Yellow: Signal
    Custom Sensor Information
    0 bar: 500mv
    100 bar: 4500mv
    Supply voltage: 8-16 volts
    Output: 0.5 Ð 4.5 volts
    Connection to a 719 or 712 Binder Plug,
    from the solder view, going to the logger
    Top right pin 1: Signal
    Bottom right pin : ground
    Top Left pin 4: not connected
    Bottom left pin 3: +VB Ð 12volts

    We Also Recommend